1. Ring-shaped ceiling lampshade: Before disassembling, you must first disconnect the main power switch of the lamp. You can only ensure the safety of disassembly and assembly after disconnecting the power supply of the host. Because the ring-shaped ceiling light is generally turned on by turning the lampshade, you must gradually remove the screws around the iron ring of the lampshade with a screwdriver. Take out the lamps.
2. Built-in ceiling lamp: Because this type of lamp is installed with the integrated gusset at the same time, it seems impossible to start when disassembling and assembling. In fact, it is not too difficult to disassemble and assemble the lampshade of this type of lamp. The built-in ceiling light is stuck in the decoration ceiling. Before taking the lampshade, we must disconnect the switching power supply first, and then remove the aluminum gusset ceiling. Then you can observe carefully, you can see the built-in The dome light is stuck with a torsion spring clip, which can only be pulled out with force.
3. Aluminum gusset ceiling light: For this type of light fixture, if you can directly use the method of rotation, the lampshade cannot be taken out. The appropriate behavior should be, remember to disconnect the power supply of the host first, then use a small screwdriver or a small thin blade to lift a corner from the edge of the aluminum gusset ceiling, and splicing and removing a random piece around the lamp, just It can be seen that there are two spring buckles on the ceiling light that are similar to the ceiling light locks. Then we use two hard plastic credit cards, insert them along the edge of the splicing, move the credit card to the other end, and pry it out with a little force. After a little gap, you can finally pull out the splicing and remove the lampshade.
4. Rectangular ceiling lamps: Compared with oval lamps, the disassembly and assembly of such lamps will be more inconvenient. First, you must disconnect the power supply of the host, and then look for the four corners around the lamp. We can use the shock box hook of the laminated glass plate to suck it on a part of the aluminum alloy profile next to it, and gradually pull it down. Pull all the way until the lampshade is removed. In the pulling process, everyone should operate slowly and not use excessive force to prevent damage to the lamps.